Steel Design Sheet 35
-
1) Question.
In order to determine the gross-sectional area of a tension member consisting of two angle sections, the allowance for holes is made as
Answer. -
2) Question.
If the tension member is normally acting as a tie in roof truss but subjected to possible reversal of stress resulting from the action of wind, the member should have slenderness ratio not greater than
Answer. -
3) Question.
Net sectional area of a tension member is equal to
Answer. -
4) Question.
A tension member subjected to axial tension is designed on the basis of its
Answer. -
5) Question.
when a pair of angles back to back in tension are connected by one leg of each angle, the net effective area of the section is taken as
Answer. -
6) Question.
In the roof trusses, the horizontal beams spanning between the two adjacent trusses are known as
Answer. -
7) Question.
Which of the following statement is wrong?
Answer. -
8) Question.
A rolled I-section provides
Answer. -
9) Question.
The beams supporting the stair steps are called as
Answer. -
10) Question.
The beams resting on purlins are known as
Answer.
