Concrete Technology Sheet 8
-
1) Question.
As per Whitney's theory, the maximum moment of resistance of the balanced section of a beam of width b and effective depth d is given by
Answer. -
2) Question.
The depth of footing for an isolated column is governed by
i) maximum mending moment
ii) shear force
iii) punching shear
The correct answer is
Answer. -
3) Question.
In the design of a front counterfort in a counterfort retaining wall, the main reinforcement is provided on
i) bottom face near counterfort
ii) top face near counterfort
iii) bottom face near centre of span
iv) top face near centre
The correct answer is
Answer. -
4) Question.
In counterfort retaining walls, the main reinforcement in the stem at support is
Answer. -
5) Question.
The temperature reinforcemnet in the vertical slab of a T- shaped R.C. retaining wall is
Answer. -
6) Question.
In T-shaped R.C. retaining walls, the main reinforcement in the stem is provided on
Answer. -
7) Question.
A T- shaped retaining wall mainly consists of
Answer. -
8) Question.
For the design of retaining walls, the minimum factor of safety against over turning is taken as
Answer. -
9) Question.
Maximum percentage reinforcement incase of slabs is limited to
Answer. -
10) Question.
Due to circumferential action of the spiral in a spirally reinforced column
Answer. -
11) Question.
The diameter of ties in a column should be
Answer. -
12) Question.
A reduction factor Cr to load carrying capacity of a long column is given by
Answer. -
13) Question.
The load carrying capacity of a helically reinforced column as compared to that of a tied column is about
Answer. -
14) Question.
The minimum cover to the ties of spirals shoukd not be less than
Answer. -
15) Question.
The minimum diameter of longitudinal bars in a column is
Answer. -
16) Question.
The limits of percentage p of the longitudinal reinforcement in a column is given by
Answer. -
17) Question.
The permissible diagonal tensile stress in reinforced brick work is
Answer. -
18) Question.
For a slab supported on its four edges with corners held down and loaded uniformly, the Marcus correction factor to the moments optained by Grashoff Rankine's theory
Answer. -
19) Question.
If the size of the panel in a flat slab is 6 m × 6 m, then as per the Indian Standard Code, the widths of the column strip and middle strip are
Answer. -
20) Question.
When shear stress exceeds the permissible limit in a slab, then it is reduced by
Answer.
